×
Menu

Powering Down

To preserve correct operation of all variants of the IFD™ TE, always use the following shutdown sequence:
 
IDFIS™ - Power Off
 
Ø     If NODES™ is open, close all testing screens and forms, and Exit from NODES™ Options.
 
Ø     Shut Down the Windows Operating System.
 
Ø     Leave the DMM and IDFIS™ Pod Switches set to ON.
 
Ø     Once the Windows Operating System has shut down and the computer has automatically turned OFF,  then press and hold the UPS OFF button until it beeps.
 
Ø     The LCD screen will immediately prompt with "Turn of UPS Yes/No", (select the up-arrow, ^ ) button associated with the 'Yes' answer, and unlike the Power-Up sequence, all components will turn off simultaneously.
 
Ø     At this point, the entire IDFIS™, except for power to the UPS itself, should have been turned OFF.
 
 
VIFD™ - Power Off
 
Ø     If NODES™ is open, close all testing screens and forms and, Exit from NODES™ Options.
 
Ø     Press the Power button to the right of the main touch-screen to power down
 
Ø     During shutdown the Status Display will flash blue – on completion it will flash green.
 
Ø     Select the large rocker switch back to the original, central position – the flashing green Status Display will extinguish.
 
 
Ncompass™ 4000 Series - Power Off
 
Ø     If NODES™ is open, close all testing screens and forms and Exit from NODES™ Options.
 
Ø     Use the Shutdown on the Windows start menu, to turn off the CC.
 
Ø     Switch OFF the Ncompass™ Analyzer by operating the red power switch located adjacent to the power supply socket on the top panel of the Analyzer.
 
Ø     Switch OFF the CC power supply at the mains input.
 
 
On completion of power down, all cables should be disconnected on the portable variants before the equipment is moved.
Made with help of Dr.Explain